Aritech AS620RF Manuel D'installation page 6

Notes on low battery level control
When battery level drops below 6 V, this information is inserted
in all transmissions to the control unit. The sound signal
doubles its operating frequency and the beacon flashes more
rapidly.
If the sound and optical signals have been bypassed using DIP
switches 5 and 6, they will activate automatically when the
batteries are low. In case of a low battery signal contact the
installer who will replace the battery.
Battery replacement
You should replace the existing battery pack with the new
AS620RF-BP alkaline battery pack only. To replace the battery
pack:
1. Take-off the internal cover and remove connector J2.
2. Remove hubs from both sides of the plastic bracket (see
Figure 6). Do not put them back after the first change of
the battery pack.
3. Take-off the battery pack, replace it with a new one, put
back the fixing bracket and insert connector J2 again.
4. Check correct operating of the siren by generating an
alarm, then put back the cover of the siren.
Note: Batteries are filled with reactive chemicals and must be
handled as hazardous waste. Check your town or city
guidelines for proper disposal.
Specifications
AS620RF wireless siren
7.5 V DC (5x1.5 size "D" alkaline
Nominal operating voltage
batteries)
Power input in standby 100 microA
Maximum power input 500 mA
Battery life 2 years *
Operating frequency 433.92 MHz
Frequency band 433.050 MHz - 434.790 MHz
Maximum power output 10 dBm E.R.P.
Radio range 100 m in open field
Sound output at 1 m 105 dB
Sound frequency 2600 to 3600 Hz or 1400 to 2000 Hz
Cut-Off timer 30 s, 60 s, 90 s
−20°C to +40°C
Operating temperature
Housing Polycarbonate
Dimensions 312 x 236 x 109 mm
without battery – 1.7 kg;
Weight
with battery – 2.460 kg
Environmental class Class IV
IP rate IP44
Approvals EN50130-5
* Assumption: 4 x switch-on and and 4 x switch-off per day; 4 alarms
per month at an operating temperature from −20°C to +40°C.
AS620RF-TR transceiver unit
Nominal operating voltage
6
12 V DC
Current consumption – nominal
Current consumption – maximal 70 mA max
Transmission frequency
Reception frequency
Operating temperature
Dimensions
Weight
Environmental class
Regulatory information
Manufacturer PLACED ON THE MARKET BY:
Carrier Fire & Security Americas Corporation Inc.
13995 Pasteur Blvd
Palm Beach Gardens, FL 33418, USA
AUTHORIZED EU REPRESENTATIVE:
Carrier Fire & Security B.V.
Kelvinstraat 7, 6003 DH Weert, Netherlands
Product warnings THESE PRODUCTS ARE INTENDED FOR SALE
and disclaimers TO AND INSTALLATION BY QUALIFIED
PROFESSIONALS. CARRIER FIRE &
SECURITY CANNOT PROVIDE ANY
ASSURANCE THAT ANY PERSON OR ENTITY
BUYING ITS PRODUCTS, INCLUDING ANY
"AUTHORIZED DEALER" OR "AUTHORIZED
RESELLER", IS PROPERLY TRAINED OR
EXPERIENCED TO CORRECTLY INSTALL FIRE
AND SECURITY RELATED PRODUCTS.
For more information on warranty disclaimers and
product safety information, please check
https://firesecurityproducts.com/policy/product-
warning/
Certification
European Union Carrier Fire & Security hereby declares that this
directives device is in compliance with the applicable
requirements and provisions of all applicable rules
and regulations, including but not limited to the
Directive 2014/53/EU. For more information see:
www.firesecurityproducts.com
REACH Product may contain substances that are also
Candidate List substances in a concentration
above 0.1% w/w, per the most recently published
Candidate List found at ECHA Web site.
Safe use information can be found at
https://firesecurityproducts.com/en/content/intrusi
on-intro
2012/19/EU (WEEE directive): Products marked
with this symbol cannot be disposed of as
unsorted municipal waste in the European Union.
For proper recycling, return this product to your
local supplier upon the purchase of equivalent
new equipment, or dispose of it at designated
collection points. For more information see:
www.recyclethis.info
This product may contain a battery that cannot be
disposed of as unsorted municipal waste in the
European Union. See the product documentation
for specific battery information. The battery is
marked with this symbol, which may include
lettering to indicate cadmium (Cd), lead (Pb), or
mercury (Hg). For proper recycling return the
battery to your supplier or to a designated
collection point. For more information see
www.recyclethis.info
20 mA
433.92 MHz
433.92 MHz
+5°C to +40°C
112 x 56 x 22 mm
0.085 kg
Class II
or scan the QR code.
P/N 1070210 • REV C • ISS 15DEC20