Niko 10-511 Mode D'emploi page 30

All manuals and user guides at all-guides.com
10-511 (-50)
Remark: Remove the lamp from the floor bell push button. If you do not remove the lamp,
it continuously uses power and you can no longer make a call!
Press function key 3 for 8s. in order to modify the ring tone of the internal unit that is
connected to the floor bell push button. You hear a confirmation tone. Press the blue door
open key. The red and green LED light. Then press function key 2 (fig.5) in order to listen
to the first ring tone. With every new press on function key 2, you hear the next ring tone.
In order to set a ring tone, wait until both LEDs go out (±8s.) and you hear a confirmation
tone. The last heard ring tone is now set.
Programming an internal call and modifying the ring tone
Programming an internal call: see 'Programming without service set (10-870)'. Press func-
tion key 3 for 8s. in order to modify the ring tone for an internal call at the internal unit.
You hear a confirmation tone. Press the blue door open key. The red and green LED light.
Then press function key 1 (fig.5) in order to hear the first ring tone. With every new press
on function key 1, you hear the next tone. In order to save a ring tone, wait until both LEDs
go out (±8s.) and you hear a confirmation tone.
Attention: You can only communicate via one internal unit at a time. If the red LED at the
internal unit blinks 3x, the line is engaged by another internal unit.
Programming without service set (10-870):
Legend:
Press key until...
Press key briefly
Let go of key
Next
30
A B E P
fig.6: connect a floor bell push button
A B E P
a b P R
16 17 23 24 25
1 3
230V~
10-511
12V 1A max
12V 1A max
LED blinks
LED lights
Type of signal
Repeat
EN