Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
10-511 (-50)
Programming possibilities per function key
- Door open key:
- standard function: switch door open relay
- switch light relay (for programming and operation, see user manual bus power supplies
10-801/10-802 and user manual service set 10-870)
- floor door open function (see 'Programming without service set (10-870)')
- Function key 1 (see 'Programming without service set (10-870)')
- send control function 8
- make internal call
- (de)activate ring-and-come-in function
- (de)activate reroute function
- Function key 2 (light switch key):
- standard function: switch light relay
- Function key 3:
- standard function: switch ring tone on/off
Remark: only one programming per key possible!
POSSIBLE SETTINGS
Switching off the ring tone on the internal unit
Press function key 3. The red LED lights if the ring tone is switched off.
Modifying the volume of the ring tone
Use the tiny wheel at the bottom of the internal unit (fig.5) in order to modify the volume.
Modifying the ring tone of the internal unit
Call via an external unit:
You can choose from 13 different ring tones for the Liberty internal unit. Press function
key 3 for ±8s. You hear a confirmation tone. Press the blue door open key. The red and
green LED light.
Call from external unit 1:
Press the blue function key in order to listen to the first ring tone. With every new press
on the blue function key, you hear the next ring tone. In order to save a ring tone, wait
until both LEDs go out (±8s.) and you hear a confirmation tone.
Call from external unit 2:
If you modify the ring tone of external unit 1, the ring tone of external unit 2 is also
automatically modified. In order to set seperate ring tones for every external unit, see
'Programming without service set (10-870)'.
Connecting a floor bell push button and modifying the ring tone
You can connect a floor bell push button (a push button with NO contact e.g. 05-540) to the
internal unit (optional). Use terminals E and P of the screw connector (fig.6).
EN
29
Publicité
