Publicité
Les langues disponibles
Les langues disponibles
"MONTFORT" - ref. 134 05 01
2.5. Smoke exit on the top
Figure 4
•
Remove the internal baffle (fig. 3).
•
Fit the sealing rope in the groove on the top and fix the
flue collar with the bolts and washers supplied.
•
Replace the internal baffle.
2.6. Smoke exit at rear
Figure 5
•
Remove the internal baffle (fig. 3) and the rear heat
shield.
•
Remove the clamp and the blanking plate fixed to the
back wall and replace it on the top.
•
Fix the flue collar at rear with the bolts and washers
supplied, ensuring there is a good seal.
•
Replace the internal baffle.
•
Remove the cut-out in the rear heat shield and re-fit.
2.7. Chimney connector
-
The appliance must be installed as close as possible
to the chimney.
-
The connector pipe must be approved for installation
with combustion products (either 24 ga. Black painted
or blued steel or 316 grade 20 ga. Stainless steel or 1
mm vitreous enamelled steel).
-
Pipe diameter must not be less than the appliance
spigot diameter. If there is no other solution, the
reduction can not be more than one diameter lower
than the flue spigot and be situated as distant as
possible from the flue connection of the appliance.
-
The connection can be either vertical or horizontal. For
horizontal connections, avoid right angle bends.
-
The join between the connection pipe and the
stovepipe, and the flue, must be leak tight.
Technical manual "1171"
All manuals and user guides at all-guides.com
Figure 5 - Smoke exit at rear
Installation instructions
Figure 3 - Removing the flue baffle
Figure 4 - Smoke exit on the top
5
Publicité
