Anton Paar DMA 35N Mode D'emploi page 33

All manuals and user guides at all-guides.com
11 Data Transfer to Printer/PC
• For data transfer from the DMA 35
interface port (option) is required.
• Interface plug:
Pin 2: TXD
Pin 3: RXD
Pin 4: DTR
Pin 5: GND
Pin 7: RTS
• Interface plug
• Printer requirements for the data transfer:
- Serial interface
- Lines TXD and DTR must have a minimum voltage of -9 V.
• Connection of the printer/PC:
Connect the DMA 35
- Slide the black connector from the rear of the DMA 35
the side of the instrument until the catch spring locks.
- The lever of the spring has to be on the rear.
B46IB01
N
Printer/PC
Warning:
Never use the interface port in hazardous areas.
to the printer/PC using the infrared/RS 232 interface port.
N
to a printer or PC the infrared/RS 232
into the 2 grooves on
N
EN
35