Fox The Evolution Plus X Manuel D'instructions page 4

Assembly
GB
Instructions
1. Holding the tips of
the aluminium poles,
fan the Evo out as
shown.
All manuals and user guides at all-guides.com
3. Taking the short centre pole,
place it into the socket on the
block opposite to where the
side pole is connected.
2. The solid bosses should be
fitted to the tip of each of the side
poles. Each pole should be fitted
so that the bosses have the pair
of sockets facing towards the
front of the Evo. Picture shows the
boss fitted to the left hand pole
6. Standing at the front of the Evo, take hold of one of the
with sockets facing in correct
short front poles and placing downward pressure onto the
position.
boss, insert the pole into the socket with the cut away. This
is best done using a light downward pressure on the boss,
while lifting and inserting the pole with the other hand.
4. Tension the Evo and connect 5. Insert the two rear poles into
the centre pole into the other the boss sockets as shown.
boss.
7. Repeat the process for the remaining
front pole.
GB