Function
• Built-in electronic circuit for operation with a conventi-
onal DC power pack (max. ±12 volts), Trix Systems or
NMRA DCC digital systems.
• Automatic system recognition between digital and
analog operation.
• The full range of functions is only available under Trix
Systems and under DCC.
• Headlights for the locomotive change over with the
direction of travel. They can be turned on and off in
digital operation.
Notes on operation with direct current
• A filtered direct voltage is required for operation.Ope-
rating systems with pulse duration control are therefore
unsuitable.
Notes on digital operation:
• The operating instructions for your central unit will give
you exact procedures for setting the different param-
eters.
• The values set at the factory were selected to guarantee
the best possible running characteristics.
• This locomotive comes from the factory programmed
for the digital address „55" Number of speed levels that
have been set: 28.
• Correct programming with the 66920 Mobile Station is
possible starting with version number 034.
All manuals and user guides at all-guides.com
• The setting done at the factory does not permit opera-
Safety Information
• This locomotive is only to be used with the operating
• This locomotive must not be supplied with power simul-
• Please make note of the safety information in the
• The feeder track must be equipped to prevent inter-
• Only the Trix decoder installed at the factory can be
tion with opposite polarity DC power in the braking
block. If you want this characteristic, you must do with-
out conventional DC power operation (CV29 / Bit 2 = 0).
system it is designed for.
taneously by more than one power source.
instructions for your operating system.
ference with radio and television reception, when the
locomotive is to be run in conventional operation. The
611 655 interference suppression set is to be used for thi-
spurpose. The interference suppression set is not suitable
for digital operation.
plugged into the 21-pin connector.
7