Flex ALP 305 Notice D'emploi page 12

Intended use
This point laser is designed for use in industry
and trade.
The power tool is designed to determine,
transfer and check horizontal courses, vertical
lines, perpendicular points and right angles,
e.g.:
– to transfer metre and height cracks,
– to mark partition walls (vertical and/or
at a right angle) and
– to align equipment and controls in three
dimensions.
Safety instructions
Danger!
– Keep children away from laser power
tools.
– Use suitable measures to prevent a third
party from looking into the laser beam
with optical instruments.
– If at all possible let the laser beam path
run above or below eye level.
– It is not permitted to tamper with or
change the power tool. Do not disable
safety devices and do not remove
information and warning signs.
– Before switching on the power tool,
check for visible damage. Do not switch
on damaged power tools.
– The power tool may be repaired by
authorised technicians only. If the power
tool is opened without authorisation,
laser radiation may be emitted which
exceeds class 2.
– Do not use the power tool in an explosive
environment.
– If carrying out alignment work on ladders,
avoid an abnormal posture. Ensure that
you have a secure footing and keep your
balance.
12
All manuals and user guides at all-guides.com
Damage to property!
– Always lock (
transporting the device.
– Do not use the machine in the rain.
– If the power tool is brought from a cold to
a warm environment or vice versa, leave
the power tool to acclimatise before
using it.
– If using adapters and tripods, ensure that
the power tool has been firmly screwed
down.
– Transport the power tool in the
appropriate transportation case only.
– If shipping the power tool or
disconnecting it for a prolonged period,
isolate the batteries or take them out of
the power tool.
– Do not open the adjusting openings
(2, 6)! Only authorised technicians may
make adjustments.
Damage to the environment!
– Dispose of power tool, battery packs and
batteries in accordance with the currently
valid national directives. If in doubt,
contact the manufacturer or supplier.
ALP305
) the switch (3) when