Miele Classic C1 SB 3 Série Mode D'emploi page 37

Activating the exhaust filter
TimeStrip change indicator
Depending on the model, your vacuum
cleaner will be fitted as standard with
one of the following exhaust filters (dia.
07).
a AirClean
b Active AirClean 30 (black)
c HEPA AirClean 30 (white)
If your vacuum cleaner is fitted with fil-
ter b or c, you need to activate the ex-
haust filter TimeStrip change indicator.
 Pull the release catch for the dust
compartment lid upwards and open
the lid as far as it will go (dia. 08).
 Remove the indicator strip (dia. 09).
 Press the exhaust filter TimeStrip
change indicator (dia. 10).
After approx. 10 - 15 seconds, a thin
red line will appear in the left hand side
of the display (dia. 11).
 Close the dust compartment lid se-
curely, making sure it clicks into posi-
tion. Take care not to trap the dust-
bag when doing so.
How the exhaust filter timestrip
works
The exhaust filter timestrip indicator
shows the remaining functional life of
the exhaust filter. After approx. 50 oper-
ating hours, or approx. one year of av-
erage use, the display will be com-
pletely filled with red (dia. 12).
Using the accessories supplied
(dia. 13 + 14)
 Dusting brush
 Upholstery nozzle
 Crevice nozzle
 Accessory holder for the three ac-
cessories supplied
Symbols on the holder show where to
attach the different accessories.
 Attach the accessories holder to the
hose connector socket at the top or
bottom of the suction hose. Make
sure it clicks into position.
Standard adjustable floorhead
(dia. 15)
For general use and also for vacuuming
the stairs.

For safety reasons when vacu-
uming stairs it is best to start at the
bottom of the stairs and move up-
wards.
Use
To unwind the mains cable
(dia. 16)
 Pull the mains cable out to the re-
quired length (max. cable length ap-
prox. 5.5 m).

If vacuuming for longer than 30
minutes, the mains cable must be
pulled out to its fullest extent. Other-
wise there is a danger of overheating
and damage.
en
37