Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
27. Place the Grille Ring over the
Front and Back Grille rims, po-
sitioning the opening of the
Grille Ring at the bottom of the
Front and Back Grille rims. Bring
the two ends of the Grille Ring
together, and secure them with
Grille Ring Latch. See Figure 14.
Grille ring latch
latch Open
latch Closed
FIGurE 14
10
operatIon
This appliance is for household use
only.
1. Place the fan on a dry, safe, flat
surface where it cannot fall or
be pulled by the cord.
2. Plug the fan into a grounded
120-volt AC electrical outlet
(ordinary household current).
Grille ring
DO NOT use any other type of
outlet. Make sure that the rated
voltage of the fan is the same as
the power source before plug-
ging it into the power source.
3. Turn the fan "ON" or "OFF"
by rotating clockwise or coun-
terclockwise the Power/Speed
Control. See Figure 15. The
power should always be OFF be-
fore unplugging the fan.
4. To select the speed, move the
Power/Speed Control from OFF
to the desired speed setting:
O (off), I (low), II (medium), III
(High).
5. To adjust the upward or down-
ward flow of air, loosen the An-
gle Adjustment Knob beneath
the Fan Motor. See Figure 15.
Position the fan to the desired
angle, and tighten the Angle
Adjust knob.
6. To make the fan oscillate, push
the Oscillation Pin down. To
stop the fan from oscillating,
pull the Oscillation Pin up. See
Figure 15.
41973-01 03/08/2006
Publicité
