Publicité
Les langues disponibles
Les langues disponibles
OPERATING INSTRUCTIONS
Before starting clipper remove blade guard. Plug cord into electrical outlet, operate
at 120 volt, 60 cycle AC electrical current or as noted on the unit. To start clipper
move switch button forward; to stop, move switch button back to original position.
After using your Andis clipper, rewrap cord and store in a safe place.
USING THE ATTACHMENT COMBS
(Some models do not have combs and sizes will vary by kit)
You can set the blades for a longer cut by using any of the attachment combs made
for your Andis clipper. The combs mount easily; simply slip the cutter blade teeth
into comb and snap the comb down. To remove, simply snap off (Figures A & B).
These attachment combs guide hair into the blades and give you precise control of
hair lengths. The length of trim is indicated on the attachment comb. Use the chart to
find the approximate lengths of cut. Different blade angles in relation to the skin,
thickness and texture of the hair will vary the cutting length.
CLIPPER BLADE ADJUSTMENT
Your Andis adjustable clipper blade set is easy to adjust. From coarse to fine cuts, all
that is needed is a flick of the adjustment lever with your thumb. In the upright
position, the blades are set for the finest, or shortest cuts (Figure C).
USER MAINTENANCE
The internal mechanism of your clipper has been permanently lubricated at the
factory. Other than the recommended maintenance described in this manual, no
other maintenance should be performed, except by Andis Company or an Andis
authorized service station. To contact Andis directly, please call our Customer
Support Team at 1-800-558-9441 or email us at support@andisco.com.
POWER ADJUSTMENT
Your Andis clipper has been adjusted to line voltage at the factory. However, because
of voltage variations, it may be necessary to adjust the power setting for your area. If
the power adjustment is off, you will usually notice a "clatter" when the clipper is on
or introduced into the hair. (It is normal for your clipper to "clatter" for an instant
when initially turned on).
4
Publicité
