Publicité
Les langues disponibles
Les langues disponibles
on the bit. Driving then stops regardless of
pressure continued by the operator.
1. Rotate the depth adjusting sleeve until the
nose piece reaches the desired position.
2. Each click of the depth adjusting sleeve
equals a 0.25mm change in depth. One full
360 degree turn equals 2mm (Fig. 2).
3. Before beginning, always test-drive a sample
screw into a piece of scrap installation material
to check desired depth setting.
REPLACING BIT TIPS AND
BIT TIP HOLDERS
1. Remove the nose piece by grasping firmly
WITH FINGERS and pulling straight out. DO
NOT USE PLIERS.
2. Remove the bit tip by grasping firmly and
pulling straight out. If the bit tip holder comes
out with the bit, separate them. If you are
replacing the bit tip holder too, grasp it firmly
and pull it straight out. If you cannot remove the
bit tip or the bit tip holder using fingers only, you
may use pliers on these two parts only (Fig. 3).
DO NOT USE PLIERS ON NOSE PIECE.
Reverse the process to the point of installing
nose piece. Then WITH YOUR FINGERS,
install nose piece by pushing inward.
CAPACITIES
Model
Nominal Capacity
SG45
All available sharp point drywall
SG45M
screws in 20 - 25 gauge studs.
SG45M-50
All available drill point drywall
SG45M-50G screws in 20 - 25 gauge studs.
SG25M
All available sharp point screws in
20 - 25 gauge studs. All available
drill point drywall screws in 14 - 20
gauge studs.
SG25MT
1/4", 5/16" & 3/8" hex head
screws.
FIG. 2
DEPTH
ADJUSTING
SLEEVE
FIG. 3
BIT
HOLDER
BIT TIP
!
WARNING
recommended in this instruction manual or the
BOSCH Catalog for this tool - may create a
hazard.
-8-
The use of any accessory or
attachment other than those
Publicité
