Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY INSTRUCTIONS
Step 1:
Insert wood dowel (EE) into vanity feet (D). Attach vanity
feet (D) to the vanity base (B) by inserting the bolts (BB)
through lock washers (CC) and flat washers (DD). Tighten
with hex wrench (FF).
Hardware Used
BB
Bolt
CC
Lock Washer
DD
Flat Washer
EE
Wood Dowel
FF
Hex Wrench
Step 2:
Mark wall for vanity placement and note the location of the
water supply lines and drain on the back panel of vanity.
Step 3:
Move vanity (B) into proper place against the wall.
v
1
EE
B
x 8
x 8
DD
x 8
x 8
v
2
x 1
v
3
B
3
ASSEMBLY INSTRUCTIONS
Step 4:
Install faucet, drain and supply lines (none included) to
vanity top (A) according to the instructions supplied with
D
those items.
DD
CC
BB
CC
Step 5:
In case of uneven floors, floor levelers are provided at the
bottom of the vanity. If necessary, adjust floor levelers by
hand to correct tilting and/or level doors.
Step 6:
To mount the backsplash (C) to the wall, apply a thin bead
of silicone compound (not included) to the unpolished
back side and bottom of the backsplash (C). Position
backsplash (C) as shown onto vanity top (A) and against
the wall. Clean any excess silicone compound before
allowing to dry.
v
4
v
5
v
6
C
Silicone
UP
A
4
A
Publicité
