Publicité
Les langues disponibles
Les langues disponibles
Initial amount of detergent:
dln
Setting the activation time:
45
45
Initial amount of rinse-aid:
rln
Setting the activation time:
10
Amount of detergent during the cycle:
dEt
Setting the activation time:
8
Amount of rinse-aid during the cycle:
rAl
Setting the activation time:
4
Exit from programming mode:
Notes for external dispensers:
dEt=181
-
if
the detergent dispenser only ope-
rates during wash pump operation; terminals 7-9
of the main terminal board are powered at the
same time.
dEt=182
-
if
the detergent dispenser only ope-
rates during filling electrovalve operation for res-
toring the boiler level; terminals 7-9 of the main
terminal board are powered at the same time.
rAi=61
-
if
the rinse-aid dispenser only opera-
tes during filling electrovalve operation for resto-
ring the boiler level; terminals 8-9 of the main
terminal board are powered at the same time.
10
All manuals and user guides at all-guides.com
1
2
1
2
1
2
1
2
GEn
rAi=62
-
if
the rinse-aid dispenser only opera-
tes during wash pump operation; terminals 8-9 of
the main terminal board are powered at the same
time.
For connections, see the wiring diagram.
Example:
Supposing that an external detergent dispenser has
been connected with a tank concentration measuring
sensor, a standard setting could be as follows:
dIn=0
the dispenser is not activated during filling of
the tank.
dEt=181
the dispenser is activated during wash
pump operation and, thanks to the concentration
measured by the conduction sensor, the correct
amount of detergent is dispensed.
Suggestion: to check the effectiveness of the rinse-
aid, look at freshly washed glasses against the light.
Drops of water remaining on the glass indicate an
insufficient amount while streaks indicate an excess.
Changing the detergent/rinse-aid type.
If changing to a different detergent/rinse-aid type
(even one by the same manufacturer), you must rinse
the suction and pressure hoses with fresh water before
connecting the new detergent/rinse-aid container.
Otherwise, the mixing of different types of detergent/
rinse-aid will cause crystallisation, which may result in
a breakdown of the dosing pump. Failure to observe
this condition will invalidate the guarantee and product
liability.
B5
MAINTENANCE
•
Descale the boiler, the internal surfaces of the tank
and the appliance water piping once or twice a
year.
•
Descale the rinse and wash jets every month using
vinegar or a descaling agent.
Prolonged period of inactivity
If the dishwasher is not to be used for a long time,
proceed as follows:
•
Close the water supply cock.
•
Completely drain the tank.
•
Remove and carefully clean the filters.
•
Completely drain the boiler.
•
Spread a thin film of Vaseline oil over all the
stainless steel surfaces.
Publicité
