Monster iSport Mode D'emploi page 9

Auto Power-Off
When the distance between the headphone and
the mobile phone is beyond effective range, you
will hear warning tone "Beep" and headphone
disconnects with the mobile phone, the headphone
will power off automatically once no active for
10 minutes.
Automatic Connection After
Powering On
When the headphone and phone have been
paired once, they will automatically connect when
the headphone is on and Bluetooth is activated
on the phone.
Connection Standby
After successful pairing and connection, you will
hear the voice prompt "Connection successful".
The headphone will be in turning on mode or
standby mode automatically and the blue LED
will flash twice every 5 seconds. When the phone
disconnects the headphone, you will hear the
disconnect tone.
Reset Paired Device(s)
Power off the headphone first, then hold
Multifunction and Volume "+" and Volume "-"
buttons simultaneously for 5 seconds, indicator
light flashes red 5 times.
Hard Reset
If the headphone cannot be turned on even when
fully charged or does not respond during use,
follow the instructions below to reset it.
1. While pressing and holding the multifunction
button, connect the headset to your PC's USB port
or a USB power adapter with the charging cable.
2. Keep pressing and holding the Multifunction
button until the headset turns on. The headset
is now reset.
Certification
FCC ID: RJE190656
This device complies with Part 15 of FCC Rules.
Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any
interference received, including interference
that may cause undesired operation. Changes or
modification not expressly approved by the party
responsible for Compliance could void the user's
authority to operate the equipment. Connecting of
peripherals requires the use of grounded shielded
signal cables. The socket-outlet shall be installed
near the equipment and shall be easily accessible.
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital