Publicité
Les langues disponibles
Les langues disponibles
3. Never use a volatile substance such a gasoline or abrasive cleaners.
4. Do not splash water onto the unit.
Storing the air conditioner
If the unit will not be used for a long time, be sure to drain the air conditioner, clean the air filter, pull out the power supply plug and wrap around power cord hooks, and remove the
batteries from the remote control before storage. After draining, keep the air conditioner running on FAN mode for at least 8 hours to dry the unit completely to prevent mold.
tRoUbleShootInG
problem
Air Conditioner does not operate
Air Conditioner runs but does not cool
Air∙Conditioner∙does∙not∙run∙and∙LED∙shows∙E4
Water is leaking from the unit
Machine automatically turns off
LED∙display∙shows∙E4
LED∙display∙shows∙E2
LED∙display∙shows∙E3
- Check and reset the power plug. Wait 3 minutes and try to run the unit again.
- The batteries in the remote may need to be replaced. Replace the batteries and try to run the unit again.
- Make sure the plug is properly plugged into the outlet.
- The set temperature may be too close to room temperature. Lower the set temperature.
- The air outlet may be blocked. Check the air outlet and remove any items that may be found.
- Check the room for open doors or windows and close them.
- There may be another appliance in the room giving off heat. Check the room and turn off the appliance.
- The air filter may be dirty. Check the filter and clean if necessary.
-∙The∙air∙exhaust∙or∙intake∙may∙be∙blocked.
- The set temperature may be too high. Check the set temperature and reduce it if necessary.
-∙There∙may∙be∙excess∙water∙in∙the∙unit.∙Drain∙the∙unit.
- Make sure unit is on a flat surface
- Drain the unit.
- Timer may have been set to shut off. Turn power back on.
- Water full. Drain the unit.
- Temperature sensor error
-∙Evaporator∙error
13
aRp-9407ca, aRp-9409ca
possible Reasons
Publicité
