Whalen Jasper ODUS-CGTDHCV Instructions D'assemblage page 6

1. Unpack the unit and confirm that you have all the hardware and required parts. Assembly the unit on a
carpeted floor or the empty carton to avoid any scratch.
2. Lay out the Left Side Frame components (A, B, C, D and E) with the holes facing up. Securely screw
the Cam Bolts (2) into the designated small holes, as shown in the illustration.
E
3
B
3. Insert one Wood Dowel (3) into the bottom middle hole of the Left Side Panel (E) as a guide. Make sure
that you use a small amount of glue with both ends of all dowels.
NOTE: It is very important to use a small amount of glue on both ends of dowels.
4. Align and attach Left Side Panel (E) to the Left Bottom Panel (B) by engaging two Cam Locks (1)
(Refer to page 2 on Cam Lock system operation supplement). As shown. Make sure that the Cam Locks
will face inward and the Cam Lock holes for the Left Back Panel (D) locate at back side.
Assembly Instructions
D
C
1
2
A
E
B
6
E
B