APEX FORGE T2 Mode D'emploi page 9

Area Summary measurement
You can get the sum of different areas of same height(such as walls)
automatically by using this measurement mode.
Switching on the tool, press button
choosing until the indication
on LCD.
-
Firstly, briefly press the button
manner as measuring the length.
-
Secondly, press the same button
same way( width 1), the first area will be automatically calculated and
displayed in the result line after getting the width value.
The measuring tool will automatically calculate the area of the wall =
Height x width 1
-
Press the same button
sum of two areas will be automatically calculated and displayed in the
result line.
The sum of the areas = Height x (width 1+ width 2)
Repeat the operations above and get the summary.
The sum of the areas = Height x (width 1+ width 2+...+ width n)
In measuring, you can delete the measured value you don't need by pressing
the button once and measure again.
Press the same button
measurement, back into length measurement.
once a time to select function, stop
for Area Summary measurement appears
to measure the height, in the same
once to measure the width in the
once to measure the 2nd width( width 2), the
twice at the same time to end the area summary
- 07 -