APEX FORGE T2 Mode D'emploi page 8

Area Measurement:
In area/surface measurements, press the button
stop choosing until the indication
on the LCD.
Afterwards, measure the length and the width by pressing the measuring
-
button once a time, one after another, in the same way as measuring the
length.
Upon completion of the second measurement, the area will be automati-
-
cally calculated and displayed in the result line. Also, the individual
measured values will show in the measured-value lines.
In measuring, you can delete the measured value you don't need by pressing
the button once and measure again.
Press the same button
ment, back into length measurement.
Volume Measurement
For volume measurements, press button
choosing until the indication
Afterwards, measure the length, width and the height, one after another,
-
in the same way as measuring the length.
Upon completion of the third measurement, the volume will be automati-
-
cally calculated and displayed in the result line. Also, the individual
measured values will be displayed in the measured-value lines.
In measuring, you can delete the measured value you don't need by pressing
the button once and measure again.
Press the same button
measurement, back into length measurement.
for area/surface measurement appears
twice at the same time to end the area measure-
for volume measurement appears on the LCD.
twice at the same time to end the volume
- 06 -
once a time to select,
once a time to select, stop