APEX FORGE T2 Mode D'emploi page 10

Indirect height measurement / Simple Pythagoras Measurement
(
The indirect measurement is used to measure distances that cannot be
measured directly because an obstacle would obstruct the laser beam or no
target surface is available as a reflector. Correct results are achieved only
when the right angles required for the respective measurement are exactly
adhered to Pythagorean Theorem(a²+b²=c²).
There are four Pythagoras modes specially-designed for users to measure
conveniently.
see figure 1)Switch on the laser tape measure, and then press the button
1.
once a time until you can see the indication
ras measurement shows on the LCD, the Hypotenuse(a) flickers firstly to
remind you to measure the value by pressing button
horizontal distance (b) flickers to remind you measure the value of "b" .
After that, the tool will automatically calculate the vertical height(x) value.
(see figure 2)Switch on the laser tape measure, and then press the button
2.
five times, then you can see the indication
measurement on LCD, measure the length one by one prompted by the
indication by pressing button
calculate the X value.
(see figure 3)Switch on the laser tape measure, and press the button
3.
six times, then you can see the indication
measurement on LCD. Press the button
prompted by the indication one by one. After that, the tool will automatical-
ly calculate the X value.
.After that, the tool will automatically
MEAS
MEAS
- 08 -
for simple Pythago-
. And then the
MEAS
for simple Pythagoras
for simple Pythagoras
I
to measure the length