Publicité
Les langues disponibles
Les langues disponibles
(see figure 4)Switch on the laser distance measure, and press the button
4.
seven times, then you can see the indication
ras measurement on LCD. Press the button to
prompted by the indication one by one. After that, the tool will automatical-
ly calculate the X value.
In Simple Pythagoras Measurement, the measuring tool can only calculate
when the side of right angle is shorter than the hypotenuse, otherwise, it will
display "ERROR". In Simple Pythagoras Measurement, in order to ensure
the accuracy of measurement, it is necessary to ensure that the measuring
tool is measured from the same starting point, and follow the measure order
indicated on LCD.
Wheel Measuring
Switching on the laser tape measure, press the button
enter into the Wheel Measuring Mode. The symbol
indicating that this tool enters into Wheel Measuring Mode for measuring the
length of curved surface. Rolling its wheel along the line to be measured and
the the result value will display in the result line, in this way you can measure
curved line or straight line in any kind of surface. It's better to draw a line
firstly on the surface to be measured to make sure the route you are going to
roll along.
In measuring, you can delete the measured value you don't need by
-
pressing the button
Briefly press the button
-
into the length measurement.
once and measure again.
MEAS
once to end the wheel measurement, back
MEAS
- 09 -
for simple Pythago-
I
measure the length
MEAS
for 3 seconds to
will show on LCD,
Publicité
