APEX FORGE T2 Mode D'emploi page 5

Unit switching
Switching on the measuring tool, its unit is 0.000m. Press the button
seconds to enter into the Unit Switching status. Then you can switch the
current unit of measurement and there are 6 units of measurement for
selection.
Units of measurement:
Length
0.000 m
1
0.00 m
2
0.0 in
3
0 1/16 in
4
0'00" 1/16
5
0.00 ft
6
Selecting the Reference Level
As a laser measure, in measuring, you can select between two different
reference planes for this laser&wheel tape measure:
– The rear measuring-tool edge (e.g. when measuring onward from a wall),
The front measuring-tool edge
–
To select the reference level, see the reference level symbol which is
indicated on the LCD, and press the button
reference level you need. Each time after switching on the measuring tool,
the rear end of the measuring tool is preset as the reference level.
The front measuring-tool edge
Area
0.000 m
2
0.00 m
2
0.00 ft
2
0.00 ft
2
0.00 ft
2
0.00 ft
2
once a time to choose the
The rear measuring-tool edge
- 03 -
for
Volume
0.000 m
3
0.00 m
3
0.00 ft
3
0.00 ft
3
0.00 ft
3
0.00 ft
3