SAINT-GOBAIN Norton Clipper JCW 600 Manuel D'utilisation page 37

VERS. 2017.07.12
6 MAINTENANCE AND SERVICING
To ensure a long-term quality from the cutting with the M400, please follow the maintenance plan
below:
Whole machine
Flange and blade fixing devices
Belts tension
Motor cooling fans
Water pump
Water pan
Water hoses and nozzles
Water pump filter
Cart guiding bars
Motor housing
Reachable nuts and screws
Maintenance of the machine
Always perform the maintenance of the machine with the machine isolated from the electrical supply.
Lubrication
The M400 uses life-lubricated bearings. Therefore, you don't need to lubricate the machine at all.
Cleaning of the machine
Your machine will last longer if you clean it thoroughly after each day of work, especially water pump,
water pan (which can be removed for easy cleaning), motor and blade flange.
Adjustment and replacement of the belts
To adjust the belts, firstly remove the belt guard by unscrewing the 4 nuts. Loose the 4 motor bolts
and shift the motor by using the two screws on the side.
To replace the belts, move the motor forward on the cutting head. Adjust the belts and retighten them
by shifting the motor to the rear of the machine.
Always use a matched set of belts. Do not replace single belts.
Visual control (general aspect,
watertightness)
Clean
Clean
Check and adjust
Clean
Clean
Clean
Clean
Clean
Clean
Clean
Tighten up
JCW 600 E_MAN_EN
17