SAINT-GOBAIN Norton Clipper JCW 600 Manuel D'utilisation page 33

VERS. 2017.07.12
3.3 Electrical connections
Check that,

the voltage/phase supply corresponds to the information indicated on the motor plate.

Available power supply must have ground connection in conformity with safety regulations.

The connecting cables should have at least a 2.5mm
3.4 Starting the machine
Open the cover on the switch and press the green button to start the machine. Either press on the red
button or directly on the switch cover to stop the machine.
3.5 Water cooling system
Fill the water pan with clean water to approximately 2cm from top (ensure that bottom of pump is fully
immersed in water).
Open the water-tap on blade guard (note that handle on water-tap should be in line with water-flow).
Ensure that water is flowing freely in the circuit and is delivered adequately to both sides of the blade,
as insufficient water supply may result in premature failure of the diamond blade.
The water pump must never run without water. Always make sure that there is enough water in the
pan and refill if necessary.
In case of frost, empty the water cooling system from its water.
4 TRANSPORT AND STORING
JCW 600 E_MAN_EN
2
-section per phase.
13