SAINT-GOBAIN Norton Clipper JCW 600 Manuel D'utilisation page 32

VERS. 2017.07.12
3 ASSEMBLY AND COMMISSIONING
The machine is delivered fully equipped (although without diamond blade). It is ready for operation
assembly the diamond blade, the feet and the conveyor cart and after connection to the appropriate
power supply.
3.1 Tool assembly
Only NORTON blades with a maximum diameter of 400 mm can be used with the JCW 600.
All tools used must be selected with regard to their maximum permitted cutting speed for the
machine's maximum permitted rotation speed.
Before mounting a new blade into the machine, switch off the machine and isolate it from the main
source of electricity.
To mount a new blade, follow these steps:

Open the shaft vent cover on the blade guard.

Loosen the hexagonal nut on the blade shaft, which holds the removable outer flange.

Remove the outer flange.

Clean the flanges and blade shaft and inspect for wear.

Mount the blade on arbor ensuring that direction of rotation is correct. Wrong direction of rotation
blunts the blade quickly.

Replace outer blade flange.

Tighten hexagonal nut with spanner supplied for this purpose.

Shut the vent cover.
The blade bore must correspond exactly to the diameter of the blade shaft. Cracked or damaged bore
is dangerous for the operator and for the machine.
3.2 Feet and conveyor cart assembly
Feet and conveyor cart are located in the water pan. Place the four feet in the four openings on each
corner of the frame. Tighten the four locking screws.
Place the conveyor cart on the guiding rails with the material stop facing the operator.
12
JCW 600 E_MAN_EN