Robot Coupe CMP 250 V.V. Mode D'emploi page 8

The immersion blender
can equally be rested
against the rim of the
container, but must be
tilted, and the bell must
not touch the bottom of the
container.
In this case, it is best to
place your free hand on
the handle guard (or
at least as far away
as possible from any
moving and cutting
parts).
Always make sure that the bell is sufficiently
immersed to avoid splashing and that the air vents
of the motor unit does not come into contact with
any liquid.
For optimum efficiency, two thirds of the foot should
be immersed in the preparation.
• WHISK FUNCTION
Y o u c a n a l s o h o l d
the appliance by the
handle with one hand,
leaving the other hand
free to hold the bowl, if
necessary.
While you process the preparation, we recommend
that you move the whisks around in the bowl,
in order to ensure that the mixture is completely
homogeneous.
We strongly advise you
to keep the whisks from
touching the sides of
the bowl. For maximum
efficiency, at least one-
fifth of the whisk length
should be immersed. We
also strongly advise you
to start the processing at
a low speed.
ASSEMBLY & DISASSEMBLY
• BLADE
Attaching the tube to the motor unit.
(only for CMP Combi)
C
B
- Unplug the machine then, align the flat side of A
the conical part C of the tube with catch B in the
aluminum casing.
- Insert the narrow portion of conical part C of the
tube into the aluminum casing.
- Turn the tube in the direction of the arrow (see
figure) until it is snugly in place.
Removing the tube from the casing
- Unplug the immersion blender.
- Turn the tube in the opposite direction of that
used to attach it.
- When it will not go any further, remove the tube
from the conical part.
Attaching the bell to the tube
T
URN TO
ATTACH BELL
A
- Unplug the immersion blender.
- Align the flat side of A the conical part of the
tube with catch B on the inside of the bell.
- Insert the conical part C into the bell. With
the washer touching the tube seal D, turn the
bell in the direction of the arrow (See figure)
to lock the bell lug E and tube lug F snugly
together.
7
01/06/2021