Robot Coupe CMP 250 V.V. Mode D'emploi page 11

W A R N I N G
The inside of the bell must not contain any
liquid or food matter besides condensation.
If any liquid or food matter should get inside
the bell, you must:
- Change the ring/blade assembly
(Ref. 89676),
- Clean and disinfect the bell and the end of the
foot to avoid all risk of contamination.
After each use:
- It is important to detach the bell to eliminate
any condensation and ensure no food matter
has seeped inside. To eliminate condensation,
simply leave the bell detached until it dries.
- When cleaning the bell and the end of the
foot, we recommend using a mild detergent.
• BLADE
The blade can be removed from the bell for
thorough cleaning. Always dry thoroughly to avoid
spotting. Wear cutting gloves.
• ALUMINUM
Use soft-metal-safe cleaning agents!
• PLASTIC
Be careful, many cleaning agents are corrosive
and are not safe for use on plastics!
Do not use strong alkaline detergent (having a
high concentration of soda or ammonia).
• WHISK HOLDER
Never immerse the whisk holder in water. Clean it
with a cloth lightly dampened (not dripping). Never
run the whisk holder through a dishwasher.
10
01/06/2021
• WHISKS
The whisks can be cleaned either by hand or in a
dishwasher.
To ensure effective cleaning, always remove the
whisk ejector.
MAINTENANCE
• BLADE
Over time the blades will become worn and will
need to be replaced. The washer and seals should
also be replaced at this time. A blade service kit is
available.
• TUBE SEAL
In order to maintain a watertight seal between the
tube and bell, inspect the seal for wear and replace
it if necessary.
• SEAL RING
The seal ring can be lubricated using a suitable
food grade grease. In order to maintain a
watertight seal, check the seal ring for wear and
replace it if necessary.
• WHISKS
The performance of the whisks depends on the
condition of the wires. The metal wires may become
worn over time. In order to ensure optimum
performance, they will need to be replaced. Do not
use a defective or damaged whisk.
• POWER CORD:
For your safety, make sure the power cord is
always in good condition. The cord is subjected to
considerable wear and tear, and must be replaced
if it is damaged in any way (cuts, burns, etc.).
Procedure for replacing the power cord:
1) Use the dismantling tool supplied with the new
replacement cord.
2) Press the push button (see photo) and pull on the
cord without releasing the dismantling tool.
1
2
3) Installing the new cord:
Connect the Easy-Plug to the motor housing.
Before doing so, make sure the electrical plug is not
connected to the power supply.
1 S
ST
TAGE
Connect the electrical plug
to the power supply.
2 S
ND
TAGE