Robot Coupe CMP 250 V.V. Mode D'emploi page 7

INTRODUCTION TO YOUR
NEW ROBOT-COUPE
IMMERSION BLENDER
Robot-Coupe has developed a complete line of
immersion blenders. The features of each are
described in the table below.
Variable
Models
speed attachment
CMP 250 V.V. • •
CMP 300 V.V. • •
CMP 350 V.V. • •
CMP 400 V.V. • •
CMP 250 Combi • •
CMP 300 Combi • •
The Robot-Coupe immersion blenders perform
a host of culinary feats. The mixer attachment
will allow you to make soups, vegetable purees
and pulps while the whisk attachment is ideal for
making pancake batter, mayonnaise, beaten egg
whites, chocolate mousse, butter sauces, whipped
cream or smooth fromage frais.
The variable speed function will enable you to
adjust the speed to suit each preparation and to
start the processing at a lower speed in order to
reduce splashing.
The immersion blender is easily assembled and
disassembled for maintenance and cleaning.
Each immersion blender is supplied with a wall
support for easy storage.
6
01/06/2021
• OPERATION
The immersion blender is equipped with electrical
current and temperature overload protection.
If the immersion blender stops unexpectedly you may
try to restart it by following steps 3-5 below. If the
Mixer Whisk
immersion blender does not restart, allow it to cool
attachment
for a period of up to 30 minutes and the temperature
overload will automatically reset. You should then be
able to restart following steps 3-5 below.
1 . C h e c k t h a t t h e
control button (CB) is in
the released position.
2. Connect the cord to
•
the power supply
•
3. Put the tube into the
product with the bell
completely immersed.
4. Press and hold down
the safety button (SB).
5. Press the control
button (CB) and the
immersion blender will
start.
6. Release the safety
button (SB).
7. To stop the immersion blender, release the
control button (CB).
• CONTINUOUS OPERATION
8. Follow steps 1-6 above, then: While the control
button (CB) is pressed, press the locking button (LB).
OPERATING
9. Release the control button (CB).
10. Release the locking button (LB), and the
THE APPLIANCE
immersion blender will run continuously.
11. To stop the immersion blender, press and
release the control button (CB).
• VARIABLE-SPEED OPERATION
Follow steps 1 to 6 above, then change the speed
of the motor by turning the button (VS) toward the
maximum or minimum as required.
It is advisable to start at a low speed when using the
whisk.
• POWER CORD
After cleaning the machine, wind the
cord around the specially designed
SB
lugs, without stretching it too much.
VS
CB
This will prolong its lifespan.
LB
• BLADE FUNCTION
For greater control, we
recommend that you
h o l d t h e i m m e r s i o n
blender by the handle
and the bottom of motor
unit. Furthermore, we
recommend that you tilt
the immersion blender
at a slight angle to
prevent the bell from
touching the bottom of
the container.
WORKING POSITION