Robot Coupe CMP 250 V.V. Mode D'emploi page 12

Make sure the plug is pushed in far enough (two
stages). If it is not, the control buttons will not
work.
W A R N I N G
From time to time, check:
- The state of the 3 buttons' watertight
membranes. Even the tiniest cracks will
allow liquid to seep in.
- The state of the blender housing. This,
should not show any signs of cracking or
any abnormal openings which could allow
access to the live components.
TROUBLE SHOOTING
At first, try to identify precisely what has caused the
immersion blender to stop.
• If it is due to a powercut if the appliance has
been unplugged (the green voltage indicator
light is off).
- Release the control button (CB).
- Check the power supply.
- Restart the immersion blender following the
p a r a g r a p h e n t i t l e d " O P E R A T I N G T H E
APPLIANCE" (page 7).
• If it is due to overheating of the machine (the
green voltage indicator light stays on)
- Release the control button (CB).
- Unplug the immersion blender.
- Wait a few minutes for the motor to cool down
and the thermal safety mechanism to be reset.
- Restart the immersion blender following the
p a r a g r a p h e n t i t l e d " O P E R A T I N G T H E
APPLIANCE" (page 7)..
• If you cannot locate the cause of the problem
- Release the control button (CB).
- Unplug the immersion blender.
- Check:
- the plug
- that the blades are free to rotate in the bell,
- the state of the power cord,
- that the drive shaft is free to rotate. To do this,
remove the bell and test the rotation of the end
of the drive shaft manually.
• If the green voltage indicator light is off, check:
- The network voltage
V
OLTAGE INDICATOR LIGHT
- Correct connection of the
cable to the wall plug.
- Correct attachment of the
cord to the handle (see
page 10).
- The state of repair of
the cord (any cut wires)
if this is the case, see
replacement procedure on page 10.
If a malfunction occurs which is not on our list of
possible faults, consult your retailer or return the
appliance to the after-sales service.
W A R N I N G
• THE BLADES ARE SHARP! It is recommended
that cutting gloves be worn when handling
the blades. Handle and store the blades with
safety in mind.
• Never try to defeat the safety mechanisms!
• Never put anything (utensils etc.) but food
material near the blades on the Immersion
Blender!
• Never overload the Immersion Blender!
• Never turn the Immersion Blender on unless
the bell is completely immersed in the
product.
• Always unplug the Immersion Blender before
doing any cleaning or maintenance!
See warranty first then;
Should your unit require service, check with
your distributor to see where local service is
available. If not or if you wish your unit to
be serviced at the factory, call for return
instructions and ship the unit prepaid to our
factory address.
PH : 1-800-824-1646
Robot-Coupe USA, Inc
Service Department Repair
264 South Perkins Street
Ridgeland, MS 39157
For service in Canada contact the Robot-Coupe
USA factory for repair instructions.
SERVICE
11
01/06/2021