Publicité
Les langues disponibles
Les langues disponibles
NOTE: Back brackets can be installed at a
1" or 6" offset. (See Figure 3)
4. After offset is determined, align the back bracket
rectangular opening with two square holes on pallet
rack upright. (See Figure 3)
Figure 3
1" Offset
Door x 2
Upper Right Hinge Pin (UR/LL) x 1
Lower Left Hinge Pin (UR/LL) x 1
PAGE 2 OF 18
BACK PANEL ASSEMBLY CONTINUED
6" Offset
Back
Bracket
Upper Right Door Hinge (UR/LL) x 1
Lower Left Door Hinge (UR/LL) x 1
Lower Right Hinge Pin (LR/UL) x 1
Upper Left Hinge Pin (LR/UL) x 1
5. Feed 1/2" carriage bolts from the outside through
square holes on the upright to the rectangular holes
on back bracket. (See Figure 4)
NOTE: Bolts should face the inside of the
enclosure.
NOTE: Use two bolts per bracket. Secure bolts
with 1/2" nuts.
Figure 4
1/2"
Carriage Bolt
6. Repeat steps 5-6 for remaining back brackets.
7.
Repeat steps 1-6 for remaining back panel.
8. Place black caps on the end of each back panel.
(See Figure 4)
DOOR PARTS
Lower Right Door Hinge (LR/UL) x 1
Upper Left Door Hinge (LR/UL) x 1
1/2" Carriage Bolt x 8
1/4 x 1/" Carriage Bolt x 2
1/4 x 2" Carriage Bolt x 4
Black
Cap
1/2" Nut
Door Hasp x 2
1/4" Nut x 6
1/2" Nut x 8
0422 IH-9889
Publicité
