Publicité
Les langues disponibles
Les langues disponibles
OPERATION INSTRUCTIONS
2. PROPANE GAS CYLINDER
• Use only 20lb propane gas
cylinder
• Propane gas cylinder sold
separately.
CAUTION
DO NOT attempt to install or
operate the propane
gas cylinder until you have
read and understood all
PROPANE GAS CYLINDER
Safety Information.
3.INSTALLING PROPANE GAS
CYLINDER
1. Make sure the propane gas
cylinder valve is closed.
The cylinder valve handle must
be turned clockwise to a full
stop.
2. Open the door.
3. Check the control knob is in
the OFF "
" position.
4. Loosen cylinder retainer bolt
by turning counterclockwise.
5. Place propane gas cylinder
upright into hole in the fire
pit base as illustration.
6. Secure propane gas cylinder
by turning the cylinder retainer
bolt clockwise until tight.
7.Close the door.
16
2. PROPANE GAS CYLINDER
18 1/4 IN (46.4cm)
Approximately
DIA: 12 1/4 IN (31.1cm)
Approximately
3. INSTALLING PROPANE GAS
CYLINDER
WARNING
• DO NOT store a spare propane cylinder
under or near this appliance.
• DO NOT connect to a remote gas supply
OPERATION INSTRUCTIONS
3.1 Connecting Propane Gas
3.1 Connecting Propane Gas Cylinder:
Cylinder
1. Make sure Propane gas
cylinder valve is closed and
control knob
is in the OFF "
" position.
2. Remove the protective cap
from the propane gas cylinder
valve.
3. Before connecting, be sure there is no debris caught in the head
of the propane gas cylinder valve, head of the regulator or in the
head of the burner and burner ports.
4. Hold the regulator in one hand and insert nipple into the cylinder outlet. Be sure the
nipple is centered in the cylinder valve outlet.
5. Hand-tighten coupling nut clockwise until it comes to a full stop. Firmly tighten by
hand only. Do not use tools.
6. Perform "Checking for leaks" section
3.2 Disconnecting Propane
3.2 Disconnecting Propane Cylinder
Gas Cylinder
1. Make sure the appliance is
cool completely (about
45Minutes)
2. Make sure Propane gas
cylinder valve is closed and
control knob is in the OFF "
"
position.
3. Turn the couple nut counterclockwise until the regulator assembly detaches.
4. Place the protective cap cover on the propane gas cylinder valve and store the
propane gas cylinder in a well- ventilated area out of the direct sunlight.
WARNING
• The hose and regulator assembly must be replaced prior to the appliance being
put intooperation if there is evidence of excessive abrasion or wear or if the hose is
damaged. The replacement hose and regulator assembly shall be specified by the
manufacturer.
• Propane gas cylinder must be properly disconnected and removed prior to moving
this fire pit.Do NOT attempt to disconnect the gas regulator from the gas cylinder
or any gas fitting while the appliance is in use.
17
Publicité
