Publicité
Les langues disponibles
Les langues disponibles
TROUBLE SHOOTING
PROBLEM
POSSIBLE CAUSE
Coupling nut and
Propane gas
regulator not fully
leak
connected
Sudden drop
in gas
Excess flow valve may
flow or
have been activated
reduce flame
height
New burner may have
1. Flame is
residual manufacturing oils
yellow or
orange
Spider webs or insect nest
2. Irregular
in burner/venturi tube
flame
Burner ports clogged or
pattern,
blocked
flame does
not run the
full length
Obstruction of gas flow
of burner
3. Flash back
(Fire in
Poor alignment of orifice to
venturi or
burner / venturi tube
burner)
24
CORRECTIVE ACTION
•Turn the couple nut to cylinder
valve until solid stop. Tighten
by hand,Tighten by Hand only.
DO NOT use tools.
• Or : Turn off gas cylinder ,
wait 5 minutes for gas clear,
follow "CHECKING FOR LEAKS".
1. Turn off the control valve.
2. Wait 5 minutes and relight
per "Lighting Instruction"
3. If flames are still too low,
reset the excess flow valve：
• Turn control valve to "OFF"
• Turn off gas cylinder . Then
disconnect regulator from gas
cylinder.
• Turn control valve to "High",
and wait 2 minute, then turn off
control valve.
• Reconnect regulator to gas
cylinder and perform a leck
check
• Relight per "lighting
instruction".
Burn fire pit for 15 minutes and
reinspect.
Clean burner / venture tube
Clean burner ports
• Clear burner / venturi tube
• Check for bent or kinked
hose.
Ensure burner / venturi tube is
properly engaged with orifice.
TROUBLE SHOOTING
PROBLEM
POSSIBLE CAUSE
High or gusting winds
Poor on propane gas
Flame goes out
Excess flow valve may
have activated
Carbon deposits on
burner port or
thermocouple
Flame seems to
Ice has built up on the
lose heat when
outside of the propane
burning in cold
gas cylinder，Because
weather
the vaporization process
is too slow.
CORRECTIVE ACTION
DO NOT use the appliance in
high winds.
Exchange, refill or replace
propane gas cylinder.
Refer to "Sudden drop in gas
flow or reduce flame height"
Clean burner and thermocouple
Or replacement part(s) may be
needed.
• Wait until the propane
cylinder warms up and
becomes unfrosted.
• DO NOT use this appliance
when outdoor temperature is
o
o
less than-40
F (-40
C ), and
propane gas cylinder is less
than 1/4 full.
• Or: exchange, refill or replace
the propane gas cylinder.
25
Publicité
