Publicité
Les langues disponibles
Les langues disponibles
CARE AND MAINTENANCE
Cleaning Surfaces
1. Wipe surfaces clean with mild dishwashing detergent or baking soda mixed with water.
2. For stubborn stains, use a citrus-based cleaner and nylon scrubbing brush.
3. Rinse clean with water.
4. Allow to air dry.
Cleaning Burner
1. Remove the rocks from fire bowl.
2. Remove all dirt/dust from the burner，ignition box and venturi area with a small brush
and or compressed air.
3. Visually inspect the burner for any rust or damage. If damage is found, replace necessary
parts.
4. Clean any clogged burner ports with a stiff wire (such as an opened paper clip).
5. Carefully replace the rocks, follow the instruction at "Assembly Instruction
• Any guard, barrier, or other protective device removed for servicing the
appliance shall be replaced prior to operating the appliance.
• DO NOT enlarge valve orifice or burner ports when cleaning the valve and
burner.
Before Storing
1. Turn off propane gas cylinder.
2. Turn control knob to "OFF" position.
3. Disconnection propane gas cylinder per "Disconnecting propane gas cylinder"
section.
4. Storage of this outdoor fire pit indoor is permissible only if the gas cylinder is
disconnected, removed from the appliance and properly stored outdoors
5. If storing this outdoor fire pit outdoors, cover the outdoor fire pit with a cover for
protection from the weather.
22
WARNING
TROUBLE SHOOTING
PROBLEM
POSSIBLE CAUSE
Propane gas cylinder
valve is closing
Coupling nut not fully
connected
Propane gas cylingder is
low or empty
Electrode and burners
are wet
The igniton wire is loose
or disconnected
Burner will
Bad igniter
not light
Battery is not fully attached
or the battery has run out.
Electrode cracked or
broken-Spark at crack
Excess rocks
Carbon deposits on burner
port or thermocouple
Obstruction of gas flow
Disengagement of burner
to control valve
CORRECTIVE ACTION
Make sure the regulator
attached to the cylinder valve,
then turn on propane gas
cylinder.
Turn the coupling nut to
cylinder valve until solid stop.
Tighten by Hand only. DO NOT
use tools.
Exchange, refill or replace the
propane gas cylinder.
If propance gas cylinder is not
empty, refer to " Sudden drop
in gas flow or reduced flame
height" as below.
Wipe dry with cloth
Reconnect wire or replacement
part(s) may be needed.
Replacement part(s) may be
needed.
Follow assembly step to
replace the "AAA" battery
Replacement part(s) may be
needed.
Remove Excess Rocks:
Lava rocks: no more than 4Lb
(1.8KG)
Glass rocks: no more than 8Lb
(3.6KG)
Clean burner and thermocouple
Or replacement part(s) may be
needed.
• Clear burner / venturi tube
• Check for bent or kinked
hose.
Re-engage burner and valve
23
Publicité
