Publicité
Les langues disponibles
Les langues disponibles
perature will be taken should also be in
the same room for at least 5 minutes be-
fore taking the reading. Whilst taking the
temperature, make sure that the patient
and thermometer are not exposed to
direct heat, sunlight or air conditioning.
• Before taking the reading, check that the
ear canal is clean and accessible; do not
clean the ear just before using the probe
as the use of hot or cold water will affect
the reading.
• Do not take a person' s temperature for at
least thirty minutes after physical effort, a
bath or after a meal.
• If the probe is pointed at a hot object,
it will perform a remote temperature
reading. To avoid such reading errors,
keep the time from when it is switched
on to when it takes the ear reading to a
minimum.
• Do not touch the sensor, the probe or
the probe cap with your fingers. If fin-
gerprints get left on the sensor, remove
them following the instructions pro-
vided in the "CARE AND MAINTENANCE"
section.
READING PROCEDURE
Important: before switching the ap-
pliance on, the probe cap must be
fitted correctly, following the instruc-
tions provided in the "Fitting the
probe cap" section.
Fitting the probe caps.
1. Place the probe cap in the hous-
ing in the thermometer case (see
diagram 1). Important: position the
probe cap making sure the adhe-
sive part, i.e. the knurled section,
(see diagram 1 ) is facing upwards.
2. Align the centre of the probe cap
with the centre of the probe.
3. Insert the probe into its seat until
you hear it click into place; this
mean it is now ready to use.
If the probe cap is not fitted correctly,
when the appliance is switched on,
the
symbol will blink on the dis-
play and it will not be possible to take
any readings (the appliance will beep
three times and no message will ap-
pear on the display).
Fig. 2
If this happens, fit the probe cap again
following the instructions provided in
points 1-3 of this section very care-
fully.
Warning! Only use dedicated probe
caps
00016395000000
Switching on the appliance and
taking readings
Press the
(ON/MEM) button on the
left side of the appliance.
Fig. 3
When the appliance is switched on,
it will run an autotest and all the seg-
ments on the display will light up.
If any segments do not light up, do
not use the thermometer under any
circumstances.
When the autotest sessions has been
completed, the thermometer display
will look like the picture in diagram 4
The thermometer is ready for use as
soon as the (ear) icon stops blinking
17
Fig. 1
Publicité
