Assembly; Fitting The Handlebar; Assembling The Guard; Dismantling The Trimmer Head - Husqvarna 536LiRX Manuel D'utilisation

Fitting the handlebar

Li-ion Li-ion
• Position the handlebar as shown. Fit the mounting
components and tighten the knob lightly.
• Put on the harness and hang the machine from the
support hook. Now make a final adjustment so that
the machine is in a comfortable working position when
it hangs from the harness.
• Tighten the knob.

Assembling the guard.

Li-ion Li-ion
• Fit the correct trimmer guard (A) for use with the
trimmer head.
2
1
• Hang the trimmer guard on the hook on the plate
holder (1).
• Bend the guard around the shaft and tighten it with the
bolt (2) on the opposite side of the shaft.
14 – English
A

ASSEMBLY

Dismantling the Trimmer Head

Check that the trimmer head is undamaged and not
cracked. Replace the trimmer head if necessary.
Press the snap-in clips on the trimmer head and remove
the trimmer head and line.
Pull out the line chute assembly.
Remove the nut holding the trimmer head and the drive
disc.
Li-ion Li-ion