GOK SBS/MA Notice De Montage Et De Service page 18

LEAK CHECK
Risk of burning or fire.
Serious burns to the skin or damage to property.
Do not use an open flame to check for function!
Leak check before start-up
Before start-up, check the product connections for leaks!
1. Close all shut-off fittings on the connected devices.
2. Slowly open the withdrawal valve or the gas cylinder valve(s).
3. If there is a safety device (e.g. EFV) between the tank and the connected device(s),
open this during the leak check.
4. Spray all connections with a foam producing substance according to EN 14291
(e.g. leak detector spray, Part no. 02 601 00).
5. Bubbles will form in the foam producing substance if there are any leaks.
If bubbles form, tighten the connections (see ASSEMBLY). If the leaks cannot be repaired,
the product must not be used.
In Germany, the test specifications according to Item 8.3 TRF 2012 must also be taken into
account.
Item 3 is not applicable to the automatic SBS, since it opens automatically after some
time.
Ammonia contained in some soaps and cleaning agents corrodes fittings.
After a couple of months, fittings that have made contact with ammonia may show
cracks or leakages.
Ammonia-containing soap and cleaning agents may not be used for this product!
START-UP
After the product has been assembled and LEAK TESTING has been carried out
successfully, it is immediately ready for operation.
1. All shut-off fittings on the connected consumers must be closed.
2. Slowly open the gas withdrawal valve or the gas cylinder valves.
3. Hold pressed the control knob of the excess flow device SBS for a few seconds.
The hose line is filled with gas.
4. Connected consumers are ready-to-operate.
5. Observe the assembly and operating manual of the connected consumers!
Item 3 is not applicable to the automatic SBS, since it opens automatically after some
time.
8 / 10
Excess flow device SBS
Excess flow device SBS