Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
11
11
Insert transmitter batteries:
•
First read
all safety notes on page 2!
•
Make sure that the transmitter is turned off - ON / OFF switch down.
•
Open the battery compartment cover on the back of the transmitter and insert four AA bat-
teries or rechargeable batteries. Ensure correct polarity!
•
Close the battery compartment cover.
•
Now turn on the transmitter. The LED lits red.
•
A fl ashing red LED and a beep sound indicates low transmitter voltage, do not operate the
model and change the transmitter batteries fi rst - or charge the transmitter batteries.
•
This is also during operation. Once the LED on the transmitter begins to fl ash or the low
voltage alarm will sound, stop fl ying immediately and change batteries - or charge the trans-
mitter batteries.
Binding:
This allows the transmitter to connect to the receiver. The components must be connected
once, this process is called „binding". This binding is the Sky Surfer 2.0 is already done in ad-
vance, so you can fl y your model right away. In case of a binding should be necessary later, do
the following:
•
Make sure that no other 2.4 GHz transmitter (eg. WLAN) is turned on in the area.
•
Turn the radio and then the Sky Surfer on.
•
Now press the button on the receiver-ESC unit of the Sky Surfer, the LED will start fl ashing
red after a short time. After a few seconds it should turn solid green again, the binding is
successful.
•
If the LED continues to fl ash red, repeat the process.
Sky Surfer 2.0 Trimm functions:
The two sticks are equipped with digital trims. A quick press of a button adjusts the neutral
position to a certain value.
•
Turn on the transmitter fi rst, then the model.
•
Move the left throttle all the way up, then all the way down (see illustration).
•
The motor must not start now, if not press the lower left trim button until the motor stops.
•
Now move the right joystick to the middle. The red servo arm underneath the motor must be
absolutely horizontal. To move it clockwise, press the right trim button, press the left in order
to move the servo arm counterclockwise.
•
Use this option even in fl ight trim. With the right control lever in the middle, the Sky Surfer
must fl y exactly straight. If the Sky Surfer fl ies a left curve, press the right trim button until it
fl ies straight ahaed. Accordingly, press the left button trim, when he fl ies to the right.
Trim
Rise / Descent
Rise / Descent
Operating Instructions Sky Surfer 2.0
Left / Right
Trim
Left / Right
32
Publicité
Table des Matières
