GRAUPNER GM Racing 2.0 RTF Manuel D'utilisation page 30

Front lines (yellow)
B
A
Pushrod
Front lines (yellow)
Hook suspension lines
Now attach the rear lines
(red) in the round eyes of
the hook suspension lines
(white) and those in the
holes of the right and left
servo rods (A). Note the
wind speed.
Indicators to control the wind speed:
- light breeze (about 16 km / h): leaves on the tree move
- moderate breeze (about 30 km / h): Leaves and small twigs in constant motion
If the wind is stronger (over 30 km / h) the Sky Surfer must never be fl own!
The model's airspeed has to be adjusted to suit the prevailing wind conditions and the pilotes
preferences, and this is done by selecting different connection holes to alter the angle of attack.
The higher the holes are chosen, the faster the model fl ies.
29
Rear lines (red) Hook up front lines (yel-
low) at the top of left
and right pusrod (A) as
shown.
Rear Lines (red)
moderate breeze:
use the fourth hole
from bottom
light breeze:
use the central hole in
the servo pushrod for
the rear lines
Operating Instructions Sky Surfer 2.0