Electrolux FR53G Notice D'utilisation page 17

Step 9
If the door is installed correctly, you will hear a click when closing the latches.
The screen-printing zone must face the inner side of
the door. Make sure that after the installation the sur‐
face of the glass panel frame on the screen-printing
zones is not rough when you touch it.
When installed correctly the door trim clicks.
Make sure that you install the internal glass panel in
the seats correctly.
11.4 How to replace: Lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
Step 1
Turn off the oven. Wait until the
oven is cold.
Back lamp
Step 1 Turn the glass cover to remove it.
Step 2 Clean the glass cover.
Step 3 Replace the lamp with a suitable 300 °C heat-resistant lamp.
Step 4 Install the glass cover.
12. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
12.1 What to do if...
In any cases not included in this table please
contact with an Authorised Service Centre.
Problem
The oven does not heat
up.
After cleaning, install the glass panel and the oven door.
Before you replace the lamp:
Disconnect the oven from the
Check if...
The fuse is blown.
Always hold the halogen lamp with a cloth to
prevent grease residue from burning on the
lamp.
Step 2
Put a cloth on the bottom of the cav‐
mains.
Problem
The door gasket is dam‐
aged.
End of Cooking - is not
set.
The lamp does not work.
A
Step 3
ity.
Check if...
Do not use the oven.
Contact an Authorised
Service Centre.
Set: End of Cooking. Re‐
fer to "Clock functions".
The lamp is burnt out.
ENGLISH 17