Publicité
Les langues disponibles
Les langues disponibles
SM125
10.
Dust extraction
Dust which occurs during your work is hazardous to health. That is why the concrete grinder must be used with a
vacuum cleaner (category M), and a dust mask has to be worn. The suitable Wet/Dry vacuum cleaner is available
as accessory. It can directly be attached to the connection on the dust hood.
Changing the brush rim
If the length of the brushes is – due to wear - smaller than 5 mm (extreme formation of dust during grinding), the
brush rim has to be replaced completely.
Therefore, remove the three fixing screws of the firm part of the dust guard and the two fixing screws of the
detachable part. Pull out the worn brush rim and replace it by a new one. Pay attention that the fastening holes in
the brush rim and the holes of the dust hood have the same same position. Screw both parts together.
11.
Instruction for Use
Switch the machine on and put it carefully on the surface you want to work on. Hold the tool with both hands and
work with circular or linear movements.
For best working results: Don't put too much pressure on the surface you want to work on.
For grinding works right into edges of the wall one segment of the dust guard can be opened.
This allows grinding on surfaces which are usually hard to reach.
Attention!
All other grinding works have to be done with the complete dust guard.
12.
Care and Maintenance
Before the beginning of maintenance or repair works you have to disconnect the plug from
the mains.
Repairs may be executed only by appropriately qualified and experienced personnel. After every repair the
machine has to be inspected by an electric specialist.
Due to its design, the machine needs a minimum of care and maintenance. However, the following points always
have to be observed:
Always keep the power tool and the ventilation slots clean.
During work, please pay attention that no particles get inside the machine.
In case of failure, a repair has to be carried out by an authorised service workshop.
13.
Environmental protection
Raw material recycling instead of waste disposal
To avoid damages on transportation, the power tool has to be delivered in a sturdy packing. Packaging as well as
unit and accessories are made of recyclable materials and can be disposed accordingly.
- 18-
5009006-00
BA-DE-GB-FR-NL (053;059)
Publicité
