Publicité
Les langues disponibles
Les langues disponibles
SM125
The tool must neither be wet nor used in humid environment.
Do not use the tool in an environment with danger of explosion.
Do not drill into asbestos-containing materials.
Modifications of the tool are prohibited.
Never use the machine without dust guard.
Use machine with partly removed dust guard in corners only.
For other applications the dust guard must always be closed.
Always check the tool, cable and plug before use and plug before use. Have damages only repaired by
specialists.
Insert the plug into the socket only when the tool switch is off.
When you work outside, the machine has to be used with a fault-current circuit breaker with max. 30 mA.
The machine should only work under supervision of somebody.
Plug and switch the machine off if it is not under supervision, in case of putting up and stripping down the
machine, in case of voltage drop or when fixing or mounting an accessory.
Switch the machine off if it stops for whatever reason. You avoid that it starts suddenly and not under
supervision.
Don't use the machine if a part of the housing is damaged or in case of damages on the switch, the cable
or plug.
Pay attention that the speed indicated on the grinding wheel meets or is higher than the max. speed
indicated on the machine.
Grinding wheels have to be stored and used carefully according to the instructions of the producer.
Check the accessories before use. Do not use any products which are broken, cracked or damaged in
another way.
Before use, make sure that the tool is correctly fixed and fastened.
Let it run idle for about 30 seconds in a safe position. If considerable vibrations occur or if other defects
are recognised, switch off immediately.
Always lead the mains and extension cable as well as the extraction hose to the back away from the
machine.
Power tools have to be inspected by a specialist in regular intervals.
Never carry the machine at its cable.
Do not touch rotating parts.
Persons under 16 years of age are not allowed to use the tool.
During use, the operator and other persons standing nearby have to wear suitable ear protectors,
a dust mask and protection goggles.
Make sure that persons in the work space are not endangered by particles flying around.
Keep the handles dry, clean and free of oil and grease.
During operation, always hold the tool with both hands.
Attention! The tool still runs for a little while after the machine was switched off.
6.
Electrical connection
Before starting the machine check the correspondence between voltage and frequency according to the data
mentioned on the identification plate. Voltage differences from + 6 % and – 10 % are allowed.
- 16-
5009006-00
BA-DE-GB-FR-NL (053;059)
Publicité
