Worx Sonicrafter WX693 Notice Originale page 9

OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE:
The power tool is intended for sawing and
remodelling wooden materials, plastic, plaster, non-
ferrous metals and fasteners (e.g. nails and clamps)
as well as for working on soft wall tiles and for dry
grinding of small surfaces. It is especially suitable for
working close to edges and for flush cutting.
ASSEMBLY AND OPERATION
Action
Mounting accessories
Mounting the sanding sheet
Operating the on/off switch
Using the variable speed dial
Remove or install battery pack
LED Light
The Variable Speed Dial can be used to set the
optimum oscillating frequency according to the
accessories used and the respective application.
Oscillation
frequency
High oscillation
frequency:
Low oscillation
frequency:
Oscillating Tool
Figure
See Fig. A-C
See Fig. D
See Fig. E
See Fig. F
See Fig. G
See Fig. H
Application
Sanding, Sawing, Rasping
and Polishing Stone and
Metal.
Scraping, Polishing
Varnishes.
9
EN