Publicité
Les langues disponibles
Les langues disponibles
Rear LED lights
The rear LED light bulbs are supplied as a set also with a coloured cover.
Open the rear hood.
Disconnect the connector of the respective rear LED light.
Unscrew the nuts and remove the light from the holder.
Screw in the new LED light and connect the connector.
6.3.4 Replacing fuses
Fuses on the machine
If a fuse is damaged the engine will immediately shut off, the mowing deck will stop and
all indicator lights on the dash board will turn off. In this case it is necessary to find the
faulty fuse and replace it with a new one. Under no circumstances should you replace
a faulty fuse with a fuse that has a higher current rating!
Take the plastic pin out of the cover under the steering wheel and remove the protective
fuse cover.
Remove the old fuse and insert a new fuse with the same rating as the initial fuse, i.e.
15A or 10A.
If even after replacing the fuse the engine or the mowing deck will not work, contact an authorised
service centre.
Under no circumstances should you attempt to remove the control unit of the electrical system!
Fuse of the 12V socket
The fuse for the 12V socket is located between the differential lock lever and the choke
and has a rating of 5A. To replace it, first remove the protective cover and then replace
the fuse with a new one.
6.3.5 Lifting the machine
If you wish to lift the riding mower, use a jack and supports.
Proceed as follows:
Place the jack underneath the gear box on the rear axle and lift the rear part of the machine.
Insert two supports underneath the ends of the axles from the inner side of the rear wheels.
Lift the front part of the machine and insert two supports under both ends of the front wheel axles.
Never lean the machine to the side where the carburettor is located. Oil could enter the air filter!
94
6.3.3b
Publicité
