3.2 Disposal of the packaging
After unpacking the machine, ensure that the packaging material is properly disposed
of or recycled. The disposal must conform to relevant waste disposal laws valid in the
user's country.
Disposal may be performed by a specialised company.
3.3 Assembly of the separately packed assemblies
Due to the technical nature of this task the machine is prepared for operation by the seller of your riding
mower (according to the following instructions).
Before starting installation, remove all covering, protective and fastening materials.
a) Install the steering wheel:
Using a hammer and a suitable rod, knock out the pin (2), which is inserted in the rod hole (1).
The steering wheel is set it two height positions, which are set by two holes in the steering wheel
rod. Select the optimal steering wheel position, attach it on to the rod (1) and turn it so that the
holes in the steering wheel and the rod align.
Reinsert the pin into the hole and knock it in using a hammer.
b) Set the appropriate tilt angle of the steering wheel:
Set the appropriate tilt angle of the steering wheel by holding back the lever (3).
c) Screw the folding frame into the correct position on the machine:
Screw out the screws for the attachment of the frame that are screwed into the washer on both
sides of the mower body.
Seat the frame on the washers. Make sure that the frame is facing in the correct direction – must
tilt towards the rear side of the machine.
Screw the frame to the washers and fully tighten the screws.
d) Connect the battery:
Open the storage area under the steering wheel and loosen the bolts on the battery pole terminals.
Black wire Place on the (+) pole of the battery and secure in place with the bolt and nut.
Brown wire Place on the (-) pole of the battery and secure in place with the bolt and nut.
Connecting the wires in opposite to that described above will damage the machine.
When disconnecting the battery, always disconnect the negative (–) pole of the battery first.
When putting the battery into operation and when performing maintenance on it, proceed according to
the instructions in the user's manual for the battery.
Also follow all safety instructions contained therein.
e) Screw the front bumper bar into the correct position on the machine:
Slide the front bumper bar forwards from the frame of the machine so that the holes in the frame
are in alignment with the holes in the bumper bar.
Screw the bumper bar in on both sides of the frame using two bolts and nuts. The bolts and nuts
are found in the plastic bag containing the machine's documentation.
Now prepare the machine for the first start up according to the following chapter.
74
3.3a
3.3b
3.3c
3.3d
3.3e