American Standard MONTERREY 7500 Serie Instructions D'installation

MONTERREY
CENTERSET LAVATORY FAUCETS
WITH GOOSENECK SPOUT
Thank you for selecting American Standard...
the benchmark of fine quality for over 100 years.
To ensure that your installation proceeds smoothly-
please read these instructions carefully before you begin.
1
Turn off water at
CAUTION
main supply
• Asesemble GASKET (1) to SHANKS (2) and insert FAUCET SHANKS
through holes of SINK.
• Assemble LOCKNUTS (3) from underside of SINK. Align BODY as far
forward as possible and secure position by tightening LOCKNUTS (3).
• Tighten the SPOUT HUB to have the spout body fixed to the faucet.
• Connect the HOT water supply to the left SHANK and the COLD water
supply to the rightSHANK using sealant, appropriate connectors, and
COUPLING NUTS (4).
To change spout to a swivel spout: (7500, & 7502)
• Unscrew SPOUT NUT (5) and remove SPOUT (6).
• Take SPOUT CLIP (7) off SPOUT (6) and remove RUBBER RING (8).
• Replace RUBBER RING (8) with seperate PLASTIC RING (9) packed
with faucet.
• Put SPOUT CLIP (7) on SPOUT.
• Reassemble SPOUT (6) to BODY.
2
GRID DRAIN ASSEMBLY (Model 5502 only)
• Apply a bead of PUTTY around underside of DRAIN PLUG FLANGE (1).
Insert DRAIN PLUG (2) into SINK drain hole.
• Hold DRAIN PLUG (2) to prevent turning and assemble GASKET (3), WASHER (4)
and LOCKNUT (5) from underneath sink.
• Insert threaded end of TAILPIECE (6) into lower end of DRAIN PLUG (2).
Connect other end to trap.
Product names listed herein are trademarks of AS America, Inc.
© AS America, Inc. 2020
INSTRUCTIONS
®
INSTALLATION
7500 Series
7501 Series
7502 Series
7545 Series
BODY
1
SINK
HOT
- 1 -
Certified to comply with ANSI A112.18.1M
6
5
8
7
9
2
1/2" O.D. SLIP
3
COLD
4
4
1
PUTTY
SINK
2
3
4
5
2
60185 Rev. 1.9 (8/20)