PRO-POINT 8348674 Mode D'emploi page 11

V1.0
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the tool does
not function properly or parts are missing. If unable to do so,
have a qualified technician service the tool.
PROBLEMS
Tool runs at
normal
speed, but
loses power
under load.
Tool runs
slowly. Air
flows slightly
from exhaust.
Tools will not
run. Air flows
freely from
exhaust.
Visit www.princessauto.com for more information
All manuals and user guides at all-guides.com
AIR NEEDLE SCALER
POSSIBLE CAUSES
Motor parts worn.
Lack of air tool oil.
Motor parts jammed
with dirt particles.
OR
Airflow blocked by
dirt.
Air regulator in
closed position.
Excessive air tool oil
in tool or build of
shipping grease.
Damage or
excessive wearing of
internal parts.
Piston is jammed.
SUGGESTED SOLUTIONS
1. Have a qualified technician
service the tool.
2. Replace tool or parts.
Pour air tool oil into air inlet
per instructions.
1. Check air inlet filter for
blockage.
2. Pour air tool lubricating oil
into air inlet as per
lubrication instructions for
clearing shipping grease.
3. Operate tool in short bursts
to clear debris.
4 If tool still jammed, clean
tool and lubricate per
lubrication instructions.
Open the air regulator to
desired airflow.
Run tool under no load for
short periods of time until
exhaust clears.
1. Have a qualified technician
service the tool.
2. Replace tool or parts.
1. Remove chisel and spring
retainer.
2. Push punch through hole in
the cylinder until resting
against the piston.
8348674
11