Fitting I.d. Disc(S) To Your Cat(S); Viewing Your Cat(S) Location; To View How Long Since The Cat(S) Last Used The Cat Flap; Training Your Cat To Use The Cat Flap Or - Pet Mate CAT MATE Elite Super Selective 355 Mode D'emploi

To cancel timer control and revert back to the normal access option:
4.3.12 Press the 'TIMER' button for 5 seconds.
4.3.13 Press the '4 WAY' button and go back through the options until you
come to 'OFF'.
4.3.14 Press the 'SET' button 3 times to keep the current clock time and return
to the normal display.

5. Fitting I.D. Disc(s) to your Cat(s)

5.1 If desired, record your cat's details on the I.D. label by writing on the label
in pen and sticking the clear waterproof cover over the writing.
5.2 IMPORTANT: Attach the Disc directly to the collar, NOT from a ring
attached to the collar) so that it is as high as possible and parallel to flap
(as shown in Fig. 7).
We recommend the use of a fabric collar without large metal attachments
(other name discs etc.).

6. Viewing Your Cat(s) Location

The LCD shows at a glance, the location of up to three cats (1-3).
The cat last went through the flap, coming into the house;
The cat last went through the flap, going out of the house.
Please note this display is only a guide to your cats' location. The cat flap
determines the location of your cat by recording its last movement through the
cat flap. The results may be misleading if the cat has an alternative entrance/exit
to the house or if the cat has followed another cat through the cat flap; if it only
puts its nose out of the cat flap etc.

7. To View How Long Since the Cat(s) Last Used the Cat Flap

7.1 To view how many hours and minutes since cats 1, 2 or 3 last used the cat
flap, press the '+' button.
7.2 The display will show the symbol for 'CAT 1' and how many hours and
minutes ago 'CAT 1' used the flap up to a maximum of 99 hours.
7.3 Press '+' again for similar information on Cats 2 and 3.
7.4 Press '+' a fourth time (or leave for 20 seconds) and the normal display will
be resumed.
8. Training Your Cat to Use the Cat Flap or if Your Cat Has Lost its
I.D. Disc
It may take a little time for your cat to get used to its new cat flap. To help your
cat get used to entering and exiting the flap, the flap can be set to 'TRAINING
MODE' by pressing and holding the 'PROGRAM' button and within 3 seconds
briefly pressing the '4 WAY' button. After 5 seconds the lock will unlock and
the 'PROGRAM' button should then be released. The 'IN & OUT' symbol will
remain flashing.
8
Please be aware that in Training Mode your cat flap will allow access for other
animals.
To exit the 'TRAINING MODE', press and hold the 'PROGRAM' button and
within 3 seconds briefly press the '4 WAY' button. After 5 seconds the flap will
re-lock and the 'PROGRAM' button should then be released.
For very hesitant cats, whilst in the 'TRAINING MODE', the cat flap can be taped
or propped open, and food used to encourage the cat to enter and exit the flap.
NOTE: We do NOT recommend that cats, particularly kittens, are left alone to
use their cat flap until you are satisfied that they are completely familiar with its
operation.

9. Battery Replacement

When the 'BATTERY INDICATOR' comes on, alkaline batteries should be
replaced. (See Section 2).
Please note, after fitting new batteries:
• 'BATTERY INDICATOR' may remain on for up to 15 minutes.
• Flap will remember all I.D. Disc(s) and microchip(s), Lock Settings and Lock
Times but 'TIMER' SETTINGS WILL NEED RESETTING. (See section 4.3).

10. Reprogramming a New I.D. Disc or Microchipped Cat

10.1 Press the 'PROGRAM' button on the circuit board (Fig. 4), for 5 seconds,
the next unused Cat number will flash and there will be lines moving
around the first 'TWO ZEROS'.
10.2 Press the '+' button to select the appropriate Cat number for a
replacement I.D. Disc or select the next available Cat number. (A 'P' next
to the Cat number indicates that it has already been programmed,
although you may reprogram as follows).
10.3 Place the front of the I.D. Disc in the tunnel opening (Fig. 5) or to program
your cat's microchip, encourage your cat to slowly pass through the tunnel
by holding the flap open as shown in Fig. 6.
10.4 When programmed, the 'TWO ZEROS' will disappear and 'Pr' will flash.
10.5 Take the I.D. Disc or your cat well away from the flap and then press the
'SET' button to save the setting.
For additional cats, up to a maximum of 9, repeat steps 10.1 to 10.5.

11. Factory Reset

To reset the cat flap back to the setting when you first bought it, press and hold
the 'PROGRAM' button and within 3 seconds press and release the
'4 WAY' button, then press and release the 'SET' button. Release the
'PROGRAM' button when all symbols show on LCD. After a period of self
checking, the 'IN & OUT' symbol will be all that is visible on the LCD display. This
procedure will erase all I.D. Disc(s) / microchip(s) and all other
settings. You will then need to re-program the I.D. Disc(s) / microchip(s)
(See Section 3).
9