How To Operate; Convert To Refrigerator - Midea MK049ASTC Manuel D'utilisation

How to operate

Follow the steps below to dispense beer from your appliance.
1. Make sure the unit is plugged into a properly grounded AC outlet.
2. Place the Drip Tray under the beer faucet to avoid messes from excess beer.
3. To dispense beer pull the Tap Handle towards you. Refer to the section on
Tapping the Beer Keg if the beer does not dispense.
4. When pouring, hold the glass steady at a 45° angle. When it is 2/3 full,
straighten the glass. Ideally, foam should have a tight creamy head and the
collar on an average glass should be 3/4" to 1" (2 to 2.5 cm) high.
5. Increase the pressure if the beer runs too slowly (see Setting the Regulator
section). Generally, 8-10 psi is recommended.
6. Cheers!

Convert to refrigerator

Follow these steps to easily convert this appliance into a refrigerator.
1. Remove all parts and hoses from the interior and exterior of the unit, including
all hoses, the CO
2. To seal off the unit, insert the Top Cabinet Plug
into the opening on the top of the cabinet.
3. Then insert the CO
hole located in the upper left corner on the
back exterior of the cabinet.
4. Arrange the included Wire Racks in the cabinet
interior to fit your refrigeration needs.
Tank and Tap .
2
Hole Plug into the CO
2
Line
2
17