Attaching Coupler To Regulator - Midea MK049ASTC Manuel D'utilisation

Attaching coupler to regulator

1. If not already inserted, insert the CO
Directional Washer into the Keg Coupler. Then
screw the CO Line onto the Keg Coupler.
2
2. Push the other end of the CO
the hole in the rear of the cabinet. Slide a
Hose Clamp onto the end of the CO
then attach the hose to the barb fitting on the
bottom of the regulator. Secure the CO
by tightening the Hose Clamp with a flathead
screwdriver.
Attaching regulator to CO
IMPORTANT! When you purchase your first keg of beer, you must also have your
CO Tank filled by a local supplier. CO
2
welding supply shops, party stores, and wherever kegs are purchased.
1. Align and hook the 4 holes of the CO
Holder with the screws on the back of the unit.
2. Make sure the white nylon High Pressure
Washer (already installed) is attached to the
Regulator.
2
Line through
2
Line,
2
Line
2
tank
2
Tanks can be filled at locations such as
2
Tank
2
12
Hose
Clamp