Use
1. Plug the mains plug into a properly installed plug socket which matches the technical
data of the device.
Massage with the device for as long as you want. We recommend that you mas-
sage for no more than 15 minutes a day. An area (e.g. neck and shoulder area)
should be massaged for no more than 5 minutes.
8. To switch off the device, move the On / Off switch to the 0 position.
9. Remove the mains plug from the plug socket.
Cleaning and Storage
PLEASE NOTE!
■
Do not use any sharp or abrasive cleaning agents or cleaning pads to clean the de-
vice. These could damage the surfaces.
1. Make sure that the device is not connected to the mains power.
2. Twist the protective cap (5) anticlockwise to remove it from the device.
3. Remove the attachment used from the massage head (4). All attachments can be
cleaned with warm water and a mild detergent.
4. Clean the device only with a slightly damp cloth. More intense soiling can be removed
with a little mild detergent.
5. Do not wrap the mains cable around the device. Regularly check it for damage.
6. Keep the device and all accessories in the respective packaging in a dry place which
is protected from sunlight and is not accessible to children or animals.
2. Place the attachments you want onto the massage head (4).
3. Put on the protective cap (5) and twist it clockwise to secure it.
4. If you wish, with the roller attachment (8) skin cream can also be
applied to the area which is to be massaged. In this case, do not
put on the protective cap.
5. To switch on the device, move the On / Off
6. Set the intensity you want from low to high
7. Hold the device by the handle (1) and gently
15
switch (10) to the position you want (I = vibra-
tion, II = vibration and infrared light).
using the dial (11).
press the massage attachment against the
skin. Do not press too fi rmly! The device
vibrates and massages.
EN